<output id="zpptj"></output>

<output id="zpptj"></output>
<form id="zpptj"><form id="zpptj"><th id="zpptj"></th></form></form>

<form id="zpptj"><form id="zpptj"></form></form>

<em id="zpptj"><form id="zpptj"><track id="zpptj"></track></form></em>

      <form id="zpptj"><form id="zpptj"><th id="zpptj"></th></form></form>

      <em id="zpptj"></em>
      歡迎來到邁格奈特官方網站!如有任何疑問請撥打全國統一服務電話400-1122-958!

      新聞中心

      您當前所在位置:首頁 > 新聞中心 > 最新動態

      最新動態

      介紹一下電磁除鐵器?運行前應進行的調試
      作者:管理員    發布于:2017-01-25 10:01:33   

      下面為大家介紹一下電磁除鐵器運行前應進行的調試:

      Here we introduce the electromagnetic iron operation should be carried out before the debugging:

      1.檢查線圈及電機的電氣絕緣性能,達到要求后方可通電試運轉。

      1 check the electrical insulation performance of the coil and the motor.

      2.除鐵器運行前用兆歐表,測量繞組對磁體外殼的絕緣電阻其值應不于10MΩ,檢查勵磁繞組的接線是否正確可靠,無誤后方準使用。

      2 separator before operation with megohmmeter, insulation resistance measurement of winding magnet shell and its value should not be in 10M, check the excitation winding wiring is correct and reliable, correct prospective use of the rear.

      3.開機前,應檢查指示油位是否在油標上限。并依次將各路開關送電,并啟動勵磁回路,檢查風機風流向外,流量表指示正確。否則,應調整風機、專用泵電器接線。

      3 before starting, check whether the oil level in the oil standard limit indicator. And then turn the switch power supply, and start the excitation loop, check the fan airflow outward, flow meter is correct. Otherwise, the fan, pump electrical wiring should be adjusted.

      4.經常觀察電壓表、電流表之讀數是否正常,不得超過其額定值。

      4 frequently observe the voltmeter, ammeter reading is normal, shall not exceed its rated value.

      5.若除鐵效果不佳,則適當調整吊高或除鐵器與機頭滾筒的前后距離。

      5 if the iron removal effect is poor, the adjustment before and after hanging high or separator and the head drum proper distance.

      以上介紹的是電磁除鐵器運行前應進行的調試,希望大家有所了解,更多信息請聯系我們

      This is in addition to the electromagnetic iron operation should be carried out before debugging, I hope you understand, please contact us for more information




      ?
      400-1122-958